Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to connect MATLAB and COMSOL directly from MATLAB?

Please login with a confirmed email address before reporting spam


Hello.

I was wondering if it is possible to establish a connection between MATLAB and COMSOL without opening COMSOL. I would like to know if there is a MATLAB command that will establish this connection.

Thanks in advance.


1 Reply Last Post 20 gen 2010, 01:55 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 gen 2010, 01:55 GMT-5
Hi

Indeed there is , its discussed in the instllation guide I believe (I'm out "of office" working from my memory;) or in the mlinterface.pdf. Its something like

comsol matalb

options like " -np 2 " for two or more processors and

"-tempdir C:\scratch"

are usefull to keep your scratch files on a large fast disk, perhaps without having the AV fiddlening also with them.

This will open matlab (not comsol) in "linked mode , to gt to the comsol GUI just type on the matlab prompt "comsol" and off you go

Good luck
Ivar
Hi Indeed there is , its discussed in the instllation guide I believe (I'm out "of office" working from my memory;) or in the mlinterface.pdf. Its something like comsol matalb options like " -np 2 " for two or more processors and "-tempdir C:\scratch" are usefull to keep your scratch files on a large fast disk, perhaps without having the AV fiddlening also with them. This will open matlab (not comsol) in "linked mode , to gt to the comsol GUI just type on the matlab prompt "comsol" and off you go Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.