FUJIFILM Dimatix Uses MEMS Simulation for Inkjet Printhead Design
Chris Menzel, FUJIFILM Dimatix, USA
FUJIFILM Dimatix, a top producer of commercial inkjet printheads, uses multiphysics simulation to develop MEMS actuators, which their newest ink deposition projects are based on. Chris Menzel, a principal scientist on the research team at FUJIFILM Dimatix, studies printhead actuation to further the design of FUJIFILM's newest unimorph diaphragm actuators.
The team used COMSOL Multiphysics® to create a model that includes the high-performance thin-film piezoelectric layer (PZT), silicon membrane, electrodes, and the pressurized ink chamber. This model enabled them to determine the deflection of the actuator in response to electrical stimulation of the PZT, gaining a better understanding of the ins and outs of their actuator and jet.
Suggested Stories
On the Cutting Edge of Hearing Aid Research
Nearly 20% of the United States population has some degree of hearing impairment. Despite the relative ...
It’s a Bird, It’s a Plane: Flow Patterns around an Oscillating Piezoelectric Fan Blade
As electronics grow smaller and smaller and are used for extensive periods of time, their internal heat loads are ...
Simulating Laser-Material Interactions
California-based Lawrence Livermore National Laboratory (LLNL) oversees the National Ignition Facility (NIF), which ...
Silent Air Cooling: A New Approach to Thermal Management
Removing heat from electronic devices is a necessity that up until now was achieved by rotary fans. Tessera, a company ...
