Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
The discharge properties in low pressure inductively coupled Ar/CH4 plasmas operating at an RF frequency of 13.56 MHz and total gas pressure of 20 mTorr are studied in this work. The calculation of gas flow is performed in coupling with the plasma simulation. The gas flow rate is varied ... Per saperne di più
Fluid injection in deep wells is a basic procedure in geothermal permeability enhancement. The retrieved changes of Pressure and Temperature are subsequently considered as sources of incremental stress and strain changes, using the elastic model from COMSOL Multiphysics®, which are then ... Per saperne di più
This paper describes the thermal and structural combined simulation on COMSOL Multiphysics® of a Microwave (MW) Fin Taper (FT) Spatial Power Combiner (SPC) Power Amplifier (PA), based on rectangular Waveguide (WG). In the SPC based PA's, the captured power is feeded by microstrip ... Per saperne di più
This work is concerned with systems possessing cyclic symmetries. In particular, we concentrate on the case in which the medium possesses infinite order cyclic symmetry, while the constitutive relations have cyclic symmetry of a lower order. We investigate the interactions between modes ... Per saperne di più
Steven Conrad received his MD degree from Louisiana State University in 1978, and his PhD degree in Biomedical Engineering from Case Western Reserve University in 1985. His clinical practice includes intensive care and emergency medicine, and his research interests include computational ... Per saperne di più
Microfluidic devices and lab-on-a-chip (LOC) require the ability to transport or pump reagents or reaction products, the ability to effectively mix small volumes of fluid, and provide direct data display. Surface acoustic wave (SAW) driven acoustic streaming generated by a piezoelectric ... Per saperne di più
Ruptured aortic aneurysm is one of the commonest cause of mortality in developed countries. To avoid it interventional repair is an effective treatment. In the recent years the development of new therapies, such as stent implantations, allows to perform this treatment more and more ... Per saperne di più
The influences of curvature effects and swirl intensities for Non-Newtonian viscous fluid flow in a curved tube have been numerically investigated by using COMSOL Multiphysics®. The twisted tape, which are located directly in front of the curved part, are used as swirl flow generators. ... Per saperne di più
Ercan Dede currently works as a Principal Scientist for the Toyota Research Institute of North America, where his research involves the multiphysics simulation and optimization of electromechanical systems for advanced vehicle applications. Dr. Dede received his Ph.D. and B.S., ... Per saperne di più
In this work, we present the performance analysis of novel micro machined Piezoresistive fluid flow pressure sensor using COMSOL Multiphysics. The principle of the sensing mechanism is based on the deflection of four sensing layers embedded on a thin membrane. The fluid passes through ... Per saperne di più