Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
Since the advent of Terhertz(THz) technology, improving the THz emission power has been one of the major research goal. One of the methods to increase the THz emission power is to increase the coupling of excitation laser light to the dielectric substrate.The field of nano-plasmonics ... Per saperne di più
Anchor loss causes a reduction in the quality factor of high frequency micromechanical resonators. This study illustrates the importance of anchor design in mitigating anchor loss in high frequency resonators. The performances of two different anchor configurations for a silicon nitride ... Per saperne di più
This paper discusses the simulation studies on a vibration based energy harvesting system to convert the undesirable mechanical vibration to useful green power. The design consists of a resonating proof mass and a spring system enclosed in housing and fixed on the source of vibration. A ... Per saperne di più
In this paper, design and analysis of a novel MEMS capacitive microphone which uses corrugations and perforations in diaphragm is presented. The corrugation and perforation in diaphragm reduces the residual stress and increases the mechanical sensitivity of diaphragm. Instead of the ... Per saperne di più
The radio-frequency(RF) plasma sources have shown great potential in various industrial applications such as thin coatings deposition and polymers modification[1,2]. Physics of low pressure RF plasmas has been investigated significantly[3]; however, this kind of plasma source is rarely ... Per saperne di più
This paper projects a novel 3D capacitive accelerometer design to identify a severe accident and initiate airbag deployment systems. It will detect the rapid negative acceleration of the vehicle to avoid the severity of the collision. Such a device demands excellent performance in terms ... Per saperne di più
A MEMS based Knudsen’s pressure gauge working in the range of 1e-5 mbar to 10 mbar is designed and simulated in COMSOL. The working principle is based on Knudsen’s forces that arise when two plates are held at different temperatures and their separation is comparable to the mean free ... Per saperne di più
INTRODUCTION: Many electrical insulation systems use a combination of gas and solid media. Typical examples considered here include the combination of solid epoxy insulation and SF6 in a gas insulated subsystem (GIS). To understand how such a system performs under DC voltages, accurate ... Per saperne di più
The variability of the design parameters caused by material properties like thermal conductivity is the major challenge in Micro Electromechanical System (MEMS). In resonator design the basic problem is that the frequency changes with temperature variation and quantitative explanation ... Per saperne di più
The XENON Dark Matter Experiment utilizes ultra-pure xenon (Xe) as a target for particle interaction in the effort to detect dark matter particles. To measure the purity of Xe, a gas purity monitor (GPM) is being developed which drifts electrons through Xe gas to detect impurities that ... Per saperne di più