Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
Piezo buzzers, made of piezoelectric material glued on a brass plate, are usually used as signaler, but the buzzer can also be used to convert mechanical into electrical energy. If acceleration influences the buzzer, the structure is bent by its mass and a voltage can be measured between ... Per saperne di più
Lubricant oil is used to ensure proper functioning of industrial machinery such as turbines, gears, bearings and compressors. Oil analysis is used to detect and quantify the presence of wear metals and other contaminants in the lubricant of oil wetted systems, by sensing the change in ... Per saperne di più
Finite element models for acoustic scattering from three dimensional underwater elastic objects, calculated in the frequency domain, are transformed to the time domain through Fourier synthesis using COMSOL Multiphysics®. The time domain mirrors the way in which experimental scattering ... Per saperne di più
PCR (Polymerase Chain Reaction) is a recent well researched technique which can be employed to obtain an amplified DNA (Deoxyribonucleic Acid). A continuous flow polymerase chain reaction with integrated MEMS based design micro heater for DNA amplification is implemented. Temperature ... Per saperne di più
Pulsed eddy current (PEC) is being developed to detect stress corrosion cracks between fasteners on the inner wing spars of the F/A-18 Hornet aircraft. The spars are located below a thick carbon/epoxy wing skin, and so cannot be detected by conventional eddy current techniques without ... Per saperne di più
The paper describes the use of COMSOL Multiphysics to simulate an ECT (Eddy Current Testing) sensor, designed to inspect the elements of the reinforcement of concrete structures. The paper describes the steps for the COMSOL simulation, and analyze the results for three configurations ... Per saperne di più
The use of Permanent Magnet Synchronous Machines (PMSM) as shaft generators is not new in marine vessels propulsion drive trains. Due to risk of fires in stator windings by internal faults, DNV GL requires the shaft generator to be electrically dead without losing propulsion. This ... Per saperne di più
A model of a cell counter sensor based on Impedance Spectroscopy (IS) has been implemented in COMSOL Multiphysics. The cell counter is a silicon-based microdevice consisting in 3D electrodes placed in a wide microchannel: cells flow in the microchannel through the electrodes to be ... Per saperne di più
Microwave impedance microscopy (MIM) is a novel mode of atomic force microscopy that can measure topography and local electrical impedance simultaneously and with nanometer spatial resolution [1]. This technique is typically used qualitatively, identifying defects in nanodevices or ... Per saperne di più
3D model of MEMS based SAW gas sensor is designed using Focused Inter Digital Transducers design. Surface displacement & Electrical potential are analyzed at resonance & anti-resonance frequencies. Operating frequency is from 8.7 MHz which acts as start band and 9.2 MHz as stop ... Per saperne di più