Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
A finite element model of a total hip replacement (THR) has been developed from the approach of modal analysis. The model is capable of determining the first 15 Eigenmodes of a THR with an artificial bone model. The model was equipped with several different defects to simulate a ... Per saperne di più
Piezo buzzers, made of piezoelectric material glued on a brass plate, are usually used as signaler, but the buzzer can also be used to convert mechanical into electrical energy. If acceleration influences the buzzer, the structure is bent by its mass and a voltage can be measured between ... Per saperne di più
Pulsed eddy current (PEC) is being developed to detect stress corrosion cracks between fasteners on the inner wing spars of the F/A-18 Hornet aircraft. The spars are located below a thick carbon/epoxy wing skin, and so cannot be detected by conventional eddy current techniques without ... Per saperne di più
A model of a cell counter sensor based on Impedance Spectroscopy (IS) has been implemented in COMSOL Multiphysics. The cell counter is a silicon-based microdevice consisting in 3D electrodes placed in a wide microchannel: cells flow in the microchannel through the electrodes to be ... Per saperne di più
This communication reports on a numeric fluid dynamics simulation on a pipe flow model. The basic background is to determine the velocity of a flowing fluid in a pipe by using the Thermal Time-Of-Flight (TTOF) method on water. The visualization of the temperature and velocity ... Per saperne di più
PCR (Polymerase Chain Reaction) is a recent well researched technique which can be employed to obtain an amplified DNA (Deoxyribonucleic Acid). A continuous flow polymerase chain reaction with integrated MEMS based design micro heater for DNA amplification is implemented. Temperature ... Per saperne di più
The paper describes the use of COMSOL Multiphysics to simulate an ECT (Eddy Current Testing) sensor, designed to inspect the elements of the reinforcement of concrete structures. The paper describes the steps for the COMSOL simulation, and analyze the results for three configurations ... Per saperne di più
There is a practical interest among composite materials manufacturers to high-speed accurate non-destructive evaluation (NDE) technology for voids inspection when these voids are natural components of such complex structures like resin insulated layer of double-sided copper-clad ... Per saperne di più
This paper aims to demonstrate the simulation of photoacoustic signals using FEM software. The Acoustics Module of the software COMSOL Multiphysics is used to calculate the response of a differential Helmholtz resonator cell. In a second part a preliminary result obtained with the ... Per saperne di più
Microwave impedance microscopy (MIM) is a novel mode of atomic force microscopy that can measure topography and local electrical impedance simultaneously and with nanometer spatial resolution [1]. This technique is typically used qualitatively, identifying defects in nanodevices or ... Per saperne di più