Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
La modellazione e simulazione multifisica favorisce l’innovazione in numerosi settori industriali e nel mondo accademico, come dimostrano le molteplici applicazioni illustrate negli articoli tecnici e nei poster presentati ogni anno da ingegneri, ricercatori e scienziati alla COMSOL Conference.
Lasciati ispirare dai recenti contributi raccolti qui sotto oppure, per trovare una presentazione specifica o filtrare i risultati per area di applicazione, anno o sede della conferenza, utilizza lo strumento di Ricerca Rapida.
Visualizza gli articoli presentati alla COMSOL Conference 2025
CO2 capture and further conversion into valuable products can be a promising solution against global warming. Normally, CO2 conversion can be achieved by chemical methods, by photocatalytic and electrocatalytic reduction [1]. Specifically for electrocatalytic reduction of CO2, challenges ... Per saperne di più
It is known that photoacoustic spectroscopy shows the highest signal-to-noise ratio compared to other spectroscopy techniques. This is due to an orthogonal detection scheme: while exciting with light we monitor soundwaves. In gaseous phase, the use of an acoustic chamber called cell ... Per saperne di più
In the framework of the high luminosity large hadron collider (HL-LHC) project, important upgrades will take place by 2024 including the installation of new superconducting magnets in which new beam screens will be placed. The beam screen is an octagonally shaped pipe inserted into the ... Per saperne di più
Various hydrocarbon compounds have been converted into pure hydrogen by using a catalyst and a palladium membrane in one reactor (PMR) in a one-step process where the reaction proceeds to almost complete conversion. Octane is converted into pure hydrogen using of a palladium membrane ... Per saperne di più
During the manufacturing of CFRP components one of the most critical process steps is the vacuum bagging. In this process several layers of material are draped separately over complex part shapes. The specific properties of each material, which are needed for the process (i. e. breather, ... Per saperne di più
We present an efficient method to compute efficiently the general solution (Green's Function) of the Poisson Equation in 3D. The method proves its effectiveness when dealing with multi-scale problems in which lower dimensional objects, such as nanotubes or nanowires (1D), are embedded in ... Per saperne di più
The Scanning Field Emission Microscopy (SFEM) is a novel technology similar to the better known Scanning Tunneling Microscopy (STM). In STM, electrons are exchanged between the outermost atom of a sharp tip and the outermost atom of a target over sub-nanometer distances by means of the ... Per saperne di più
The coaxial magnetic gear is a good alternative to classic mechanical gears. The magnetic gear has high mechanical durability, overload protection and lower noise, than a mechanical gear [1,2]. A static model of a magnetic gear [3,4] is used for simulation of the magnetic fields and ... Per saperne di più
The aim of this paper is to optimize with COMSOL Multiphysics® simulation, the design geometry of a near field biosensor which could be used for dielectrophoretic (DEP) immobilization and simultaneous sensing of biomolecules of the order of nanometers to micrometers. COMSOL Multiphysics® ... Per saperne di più
One of the challenges associated with the wire-arc additive manufacture (WAAM) of metals is to provide adequate inert gas shielding, not only for the molten pool, but also for the long reactive metal surface that follows it. For Ti-6Al-4V, it has been shown that increased levels of ... Per saperne di più
