Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
Introduction: In inductively coupled plasma (ICP) systems the inductive antenna is coupled to the excited plasma inside the low pressure gas reactor. A multi-ICP system can be used for increased area processing and provide additional variables for controlling the plasma. However, ... Per saperne di più
A laboratory-scale fluorine reactor was simulated with COMSOL Multiphysics®. This model employs fundamental fully coupled electron-, heat-, mass- and momentum transfer (two-phase) equations to deliver a transient model of the above-mentioned reactor. Quasi-steady-state results were ... Per saperne di più
Different types of technologies to recycle carbon fiber reinforced polymer (CFRP) waste have been studied, for example: pyrolysis, solvolysis and steam-thermolysis. The steam-thermolysis is a process that combines pyrolysis and superheated steam at atmospheric pressure to decompose the ... Per saperne di più
Chemical reactions performed under microwave irradiation often have high reaction rates and high selectivities, which enable reactor sizes to be compact and processes to be energy-conserving. A microwave oven is widely used for microwave chemical processing and chemical synthesis. The ... Per saperne di più
The time-dependent operation of methanol, ammonia, and urea production units embedded in a steel mill technical environment is analyzed with dynamic simulation models. From different process concepts and gas availability scenarios a set of simulation cases is defined with blast furnace ... Per saperne di più
Three-dimensional (3D) printed 0.52 wt.% Fe/SiC monoliths with interconnected channels, fabricated by direct ink printing or Robocasting, are feasible and robust catalysts for the hydroxylation of phenol to dihydroxybenzenes using hydrogen peroxide as oxidant in aqueous media [1]. ... Per saperne di più
The versatility of the 3D printing technology has allowed developing originally structured catalysts for interesting reactions, for instance, the 0.5wt.%Fe/SiC monoliths for the treatment of industrial wastewater. These monolithic structures, manufactured by Robocasting, have ... Per saperne di più
It is desired to design a photobioreactor for the production of voluminous samples of microalgae for lipid quantification. The reactor should provide good growing conditions even with periodic withdrawal of samples. It also should be compact for better use of laboratory space. Therefore, ... Per saperne di più
Introduction: Development of next-generation chemical processes that have zero emissions is a key environmental objective for sustainable development. The manufacture of H2SO4 by the air oxidation of SO2 to SO3 is an important technology where an opportunity exists for new catalyst ... Per saperne di più
In the core of Chemical Engineering is the reactor design that includes most of all scientific disciplines. The reactors, in general, are treated ideally. Unfortunately, it is observed in the real world a very different behavior from that expected. Thus, to characterize nonideal ... Per saperne di più