Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
This paper describes the development of a COMSOL model of Electro-Chemical-Mechanical Planarization (ECMP) that was validated with experimental data. ECMP is used for processing of semiconductor wafers. We developed a 2D model of flow of phosphoric acid solution (the electrolyte) between ... Per saperne di più
Understanding the interactions between microbubbles and surfaces is key to the successful deployment of microbubbles in a range of applications. Two important examples are their use as a drug delivery mechanism, and their potential use of acoustically-driven bubbles as microscale ... Per saperne di più
The paper aims to clarify some aspects of the gases hydro-dynamics within the twisted conduct of heat accumulation stoves (ceramic-refractory stoves) downstream the combustion chamber. Both Comsol laminar and k-e turbulent models have been used in case of straight and curved pipes with ... Per saperne di più
A three Dimensional model of the PEM Fuel cell is implemented using COMSOL Multiphysics and the channel width is varied to study the performance.Effect of channel width on the performance of the cell is studied by varying the width of the channel and keeping channel width to rib ratio ... Per saperne di più
3D model of MEMS based SAW gas sensor is designed using Focused Inter Digital Transducers design. Surface displacement & Electrical potential are analyzed at resonance & anti-resonance frequencies. Operating frequency is from 8.7 MHz which acts as start band and 9.2 MHz as stop ... Per saperne di più
High-intensity discharge (HID) lamps are energy-efficient light sources with excellent color qualities. A three-dimensional model of a low-wattage lamp, which includes plasma, electrodes, and burner walls, was developed in COMSOL Multiphysics®. Most parameters appearing in the coupled ... Per saperne di più
The work is focused on the numerical analysis of forced convection in curved tubes investigating the correlation between the heat transfer and friction factor enhancement and the effects of the wall curvature. The analysis was performed by integrating the continuity, momentum and energy ... Per saperne di più
Introduction: The dual electromagnet configuration of Active Magnetic Levitation system (AML) where the electromagnets are locate opposite to each other, constitutes and single axis of the Active Magnetic Bearing. The same configuration can be used to test the single electromagnet AML ... Per saperne di più
Heating or cooling of stored fluids by thermal energy exchange with the enclosing walls may be enhanced by improving the efficiency of energy transfer; energy loss to the ambient is equalized for all simulations. Buoyancy driven internal natural convective flow is assumed to be the main ... Per saperne di più
Tetrafluoroethylene (TFE) is a gas widely employed in industry, which can under specific circumstances experience an exothermic dimerization to octafluorocyclobutane. If the heat generated by this reaction cannot be dissipated to the surroundings, the temperature inside the reactor will ... Per saperne di più
