Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
La modellazione e simulazione multifisica favorisce l’innovazione in numerosi settori industriali e nel mondo accademico, come dimostrano le molteplici applicazioni illustrate negli articoli tecnici e nei poster presentati ogni anno da ingegneri, ricercatori e scienziati alla COMSOL Conference.
Lasciati ispirare dai recenti contributi raccolti qui sotto oppure, per trovare una presentazione specifica o filtrare i risultati per area di applicazione, anno o sede della conferenza, utilizza lo strumento di Ricerca Rapida.
Visualizza gli articoli presentati alla COMSOL Conference 2025
Pumping liquids at small scales is challenging because of the principle of reversibility: in a viscous regime, the flow streamlines through a fixed geometry are the same regardless of flow direction. Recently we developed a class of microfluidic pump designs based on tilted flexible ... Per saperne di più
A device for monitoring the oxygen consumption of cells has been developed, which consists of two parts; a cell culturing platform (CCP) and an oxygen sensing chip. The CCP possesses inlet and outlet pipes to direct the fluid under the test to the cell culturing chamber through the inlet ... Per saperne di più
Multiphase flow in a microreactor was studied numerically for two immiscible liquids. Validation of the model was sought by simulating the flow behavior and mass transfer characteristics of a neutralization reaction described in the literature. Contact angles, interfacial tension and the ... Per saperne di più
This paper presents the results of modeling of a microreactor with three inputs geometry (or crow's-feet), in relation to distributions of velocities and concentrations. The objective of this work is the study of this kind of geometry with relation to fluid dynamics behavior, improving ... Per saperne di più
In this numerical study, surface acoustic waves (SAWs) are evaluated as a potential disruptive flow technology for enhancing heat transfer in microchannels. Using COMSOL Multiphysics® software, the physics governing acoustics, single-phase-fluid flow and heat transfer are coupled. The ... Per saperne di più
This paper presents the 3D model of pressure distribution in the process of magneto-rheological flow finishing. The effect of working gap on pressure distribution is studied using COMSOL Multiphysics® software. Also, the effect of different viscosity of fluids on development of pressure ... Per saperne di più
Flexography is a roll-based mass printing process used in manufacture of printed products such as sensors, self-cleaning surfaces, and flexible electronics. Flexography involves inking of a stamp wrapped around a roller, and the transfer of ink on the stamp surface to a printing ... Per saperne di più
Microcontact printing is a method for depositing patterns of thin films or molecular monolayers on surfaces using a polydimethylsiloxane (PDMS) stamp for selective mechanical contact (Figure 1). Undesired deformation of the stamp features during printing affects printed pattern quality. ... Per saperne di più
In our study of chaotic mixing, 3D velocity measurements (u,v,w) are required for evaluation of a micro mixer using a mix-prediction algorithm. The hybrid approach presented here combines 2D measurements, an imperfect numerical model, and appropriate fitting parameters. Because our ... Per saperne di più
AC electrothermal (ACET) micropumps are based on the temperature gradient caused by Joule heating or an external heat source in the bulk of an electrolyte. In this paper, a 2D simulation was performed to study the effect of substrate thickness and material (glass and silicon) for an ACET ... Per saperne di più
