Presentazioni e Articoli Tecnici

Ricerca rapida

Risorse

White paper e Appunti applicativi

Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo

In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.

Visualizza gli articoli presentati alla COMSOL Conference 2020

All

Bengaluru 2023

Munich 2023

Heat Transfer and Phase Changex

Phase-field Method in Analysis of Nanocomposite Morphological Stability

A. Klishin[1], M. J. Demkowicz[1]
[1]Massachusetts Institute of Technology, Cambridge, MA, USA

Cu-Nb multilayer nanocomposite has prospective applications in nuclear industry because of its ability to self-heal from radiation damage. The goal of the study is to find a suitable joining method for the composite to produce industrial-scale pieces, free of defects threatening the ... Per saperne di più

Use of Simulation in the Development of Next-generation Measurement Standards for Radiation Dosimetry

R. E. Tosh[1], H. Chen-Mayer[1]
[1]NIST, Gaithersburg, MD, USA

Calibration of field instruments used in radiation treatment clinics is currently traceable to NIST primary standards via protocols involving static, flat-field radiation beams. By contrast, radiation beams prescribed for treating cancer incorporate temporal and spatial modulation ... Per saperne di più

Simulation of Radiation Dose from Diagnostic X-ray Beams

H. Chen-Mayer[1], R. E. Tosh[1]
[1]NIST, Gaithersburg, MD, USA

Direct realization of absorbed dose to water in diagnostic radiation via calorimetric methods poses many challenges since the thermal signal of interest may be less than a few microKelvin. In actual biological systems or structures, like the lung, there is the additional complication of ... Per saperne di più

Phase-sensitive Microcalorimetry for Study of Low-level Radioactive Sources

H. Chen-Mayer[1], R. E. Tosh[1]
[1]NIST, Gaithersburg, MD, USA

Microcalorimetry for standardizing activities of radionuclide samples entails measurements of input power heat flow from the sample cell, with the radioactive sample compared to the reference cell under balanced conditions. The measurement is susceptible to noise due to drift and 1/f ... Per saperne di più

Finite Element Analysis of Photoacoustic Response from Gold Nanoparticle

Y. Davletshin[1], J. C. Kumaradas[1]
[1]Ryerson University, Toronto, ON, Canada

Photoacoustic (PA) imaging has matured into a clinical modality for tissue imaging and functional cancer cell research. It uses a pulsed laser to irradiate a region and generate a thermally-induced acoustic pressure wave that can be collected by an ultrasound transducer. The optical ... Per saperne di più

Convective Cooling of Electronic Components

J. Crompton[1], H. Singh[1], K. Koppenhoefer[1]
[1]AltaSim Technologies, Columbus, OH, USA

The time-dependent fluid flow and thermal interactions have been solved for transient and steady state conditions of the conjugate heat transfer problem between the natural convective flow and heat sinks composed of arrays of pins. The increased ratio of convective to conductive heat ... Per saperne di più

Chemical Reaction Under Highly Precise Microwave Irradiation

S. Fujii[1], Y. Wada[2]
[1]Chiba University, Chiba, Japan
[2]Tokyo Institute of Technology, Tokyo, Japan

Chemical reactions conducted under microwave irradiation have high reaction rates and high selectivity, but these reaction rates are not always reproducible. To achieve reproducibility, a solid-state microwave source with an ultra precise oscillator, high power amplifier module (HPA), ... Per saperne di più

Application of COMSOL Multiphysics® Pipe Flow Module to Develop a High Flux Isotope Reactor (HFIR) System Loop Model

P. K. Jain[1], D. Wang[1], J. D. Freels[1]
[1]Oak Ridge National Laboratory, Oak Ridge, TN, USA

Oak Ridge National Laboratory’s High Flux Isotope Reactor (HFIR) is the highest flux reactor-based source of neutrons for research in the United States. Thermal and cold neutrons produced by HFIR are used to study physics, chemistry, material science, engineering, and biology. Currently, ... Per saperne di più

Advancements in Carbon Dioxide and Water Vapor Separations Using COMSOL Multiphysics®

J. Knox[1], R. Coker[1], R. Cummings[1], C. Gomez[1], G. Schunk[1]
[1]NASA, Marshall Space Flight Center, Huntsville, AL, USA

Some NASA efforts are focused on improving current systems that utilize fixed beds of sorbent pellets by evaluating structured sorbents, seeking more robust pelletized sorbents, and examining alternate bed configurations to improve system efficiency and reliability. For the bulk ... Per saperne di più

Investigation of Thermal Contact Gas Gap Conductance Using COMSOL Multiphysics®

J. D. Freels[1], P. K. Jain[1], C. J. Hurt[2]
[1]Oak Ridge National Laboratory, Oak Ridge, TN, USA
[2]The University of Tennessee, Knoxville, TN, USA

Our safety analysis group in the Research Reactors Division of Oak Ridge National Laboratory supports a project to investigate the production of Pu-238 isotope for missions of deep space travel in the High Flux Research Reactor. COMSOL Multiphysics® has been used to support this activity ... Per saperne di più

Primo

671–680 of 1060

Prossimo

Ultimo