Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
La modellazione e simulazione multifisica favorisce l’innovazione in numerosi settori industriali e nel mondo accademico, come dimostrano le molteplici applicazioni illustrate negli articoli tecnici e nei poster presentati ogni anno da ingegneri, ricercatori e scienziati alla COMSOL Conference.
Lasciati ispirare dai recenti contributi raccolti qui sotto oppure, per trovare una presentazione specifica o filtrare i risultati per area di applicazione, anno o sede della conferenza, utilizza lo strumento di Ricerca Rapida.
Visualizza gli articoli presentati alla COMSOL Conference 2025
A human torso model was created for heat transfer analysis. The torso was derived from the ‘Virtual Family’ whole-body voxel data from the ITIS Foundation (Zurich, Switzerland). Measurements were taken from the ITIS male along the axial plane at key anatomical landmarks and used to ... Per saperne di più
In this section, we simulate the heat exchanger system in one dimension characterized by two coaxial tubes with ribbed inner tube using the equations of conservation of mass, conservation of momentum and energy. The COMSOL PDE interface is used to simulate the monophasic and biphasic ... Per saperne di più
Energy piles transfer the mechanical loads from buildings to the ground and serve as heat exchangers. Temperature changes in the ground influence its moisture content. This paper examines the effect of soil moisture content on the shaft resistance of a pile. Tests were carried out in ... Per saperne di più
Geothermal heat pump technology is actually one of the most interesting processes to provide heat and cold to a building. In this study, a model of the ground exchanger of a direct expansion geothermal heat pump (DX) is going to be presented in 1 dimension. The model represents the phase ... Per saperne di più
Performance degradation of a superconducting RF cavity after quenching in an external magnetic field was calculated using COMSOL. This degradation is due to the increased resistance of a superconducting surface with trapped magnetic flux. The amount of the trapped flux depends on the ... Per saperne di più
Heat sinks for cryogenic applications using helium gas as the coolant are not readily available. They require to be designed specifically for the intended application. A finite element model was developed to study the feasibility and optimize the design. The FEM computing package COMSOL ... Per saperne di più
The radiation dose produced by an x-ray CT scanner to the patient is conventionally referenced to measurements performed by an ionization chamber in a phantom. On a fundamental level, the radiation absorbed dose, J/kg, can be determined directly by the temperature rise in the absorbing ... Per saperne di più
An FEA model of a steady state thermal interface material characterization apparatus was created in COMSOL Multiphysics 4.2a. This model was then fitted using three convection heat loss coefficients and the conductance of the TIM layer to a set of experimental measurements made using a ... Per saperne di più
