Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
PCM simulation setup in COMSOL Multiphysics.
Posted 15 lug 2025, 01:25 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Heat Transfer, Results & Visualization, Studies & Solvers, Physics Interfaces Version 6.0 0 Replies
Please login with a confirmed email address before reporting spam
How to do PCM simulation setup in COMSOL Multiphysics. https://drive.google.com/file/d/1QJDjC4hOGsd8K3qDd_vl-luYoqq_sv8j/view?usp=drive_link
My study is cooling of battery cell by using both PCM and air.The cell is covered with cylinder PCM and again it is covered with aluminium casing cylinder.The aluminum casing is cooled by blowing air at some velocities. Here heat transfer takes place from cell to PCM,PCM to alumnium casing and alumiumuin casing to air.I have doubt about PCM simulation setup. Since when PCM melts its density changes and also other property changes with temperature. How to setup the simulation in COMSOL for a natural convection of PCM. when PCM melts, it converts solid into liquid.How to set physics for above problem.
Hello Ravikumar Talapati
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.