Coil/Magnet Simulation

Please login with a confirmed email address before reporting spam

I am modeling an electro-magnet and comparing the results with some measurements. The results are fairly accurate except as you approach the area close to the boundary between the steel and the air domain.

I am just using a tetrahedral mesh. Is there a particular approach I need to take for this boundary?


0 Replies Last Post 25 giu 2025, 19:28 CEST
COMSOL Moderator

Hello Gerard McGleenan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.