Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Display only Deformed Geometry in Results Node

Posted 25 gen 2025, 00:15 CET Results & Visualization 1 Reply

Jason Silver
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

This is a pretty basic question, but I have searched online and haven't been able to find an answer. I am performing a Static/Stationary structural simulation, and when I create a Results-Volume-Deformation node, I see the deformed geometry overlaid with the undeformed wireframe. Is there a setting to turn off the display of the undeformed geometry in this node?

1 Reply Last Post 25 gen 2025, 00:33 CET
David Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 months ago 25 gen 2025, 00:33 CET

If you go up to the parent plot group you will see a check box labeled Plot Dataset Edges.

If you go up to the parent plot group you will see a check box labeled Plot Dataset Edges.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content