Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

High current output

Please login with a confirmed email address before reporting spam

Hi everyone,

I am simulating a heat treatment with the induction heating module and I'm facing a problem concerning the single turn coil.
More specific I import as a coil excitation the a power of 640kW and I get a voltage of 120V and 10700A.
The voltage is fine, but the current is the double of what I expected. Any ideas of how can I fix this or check what's wrong?

Thank you!
Rosa

3 Replies Last Post 18 gen 2013, 08:22 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 gen 2013, 03:23 GMT-5
Hi

could it be an issue with a mix of Amplitudes and RMS values ?

--
Good luck
Ivar
Hi could it be an issue with a mix of Amplitudes and RMS values ? -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 gen 2013, 07:18 GMT-5
I haven't specified any value as a rms so there is no mix. Right?
I haven't specified any value as a rms so there is no mix. Right?

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 gen 2013, 08:22 GMT-5
Hi

not necessarily, normally we specify amplitudes, but depending on the physics (and the version) at some stage COMSOL proposed back RMS values for frequency sweep analysis, need to look up the appropriate doc (corresponding to your current version, or dig into the COMSOL equations (preferences view equations on)


--
Good luck
Ivar
Hi not necessarily, normally we specify amplitudes, but depending on the physics (and the version) at some stage COMSOL proposed back RMS values for frequency sweep analysis, need to look up the appropriate doc (corresponding to your current version, or dig into the COMSOL equations (preferences view equations on) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.