Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Common boundary but normal independant

Please login with a confirmed email address before reporting spam

Hi everybody,


I am a trainee in Aerospace and I am doing a model about welding, I use Heat transfer and Structural analysis, because I want to make a model of laminate's displacement.

I use COMSOL 3.5a, and one of my part to weld is on wood, so there is a common boundary between wood and laminate. The problem is that I want to see the deformation of the laminate, because normally it is going up but the wood does not have to go up with laminate. I want to know if I can separate wood from laminate in boundaries conditions ? And how to do it, please ?


I give you a picture of my geometry for your understanding.


Thanks for your replies and sorry for my English, I am French.


F.YVON


0 Replies Last Post 21 nov 2012, 09:44 GMT-5
COMSOL Moderator

Hello Florent Yvon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.