Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

piezo-acoustic-ACDC interaction: results not consistent with experiment

Please login with a confirmed email address before reporting spam

Dear All,

I am trying to model a buzzer that consists of Al membrane and PZT patch. The buzzer is excited by acoustic wave (given pressure) and is loaded with a resistive load. I cut the geometry in half and used symmetry (please see attachment). My problem is that the voltage across the load resistor in comsol is about 10 times smaller than the voltage measured in the experiment (both at their resonance frequency), and the collected power is about 100 times smaller. I tried different meshes and boundary conditions, but the results stay similar and wrong. Could anyone look at the model and make a suggestion? I would appreciate it very much.

Victor Klymko
postdoc, Eindhoven University of Technology


0 Replies Last Post 22 ott 2012, 12:22 GMT-4
COMSOL Moderator

Hello Victor Klymko

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.