Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem in Submodeling Post Processing .

Posted 4 lug 2022, 10:18 GMT-4 General, Results & Visualization, Structural Mechanics Version 6.0 1 Reply

Shyam Kishor
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Everyone,

I modelled a submodelling to find out stresses in a submodel from the the main model. While I am visulizing the stress surface results it is showing two surfaces one with stress contours and other one just geometry. ( as shown in figure attached) I want to show only stress plot, How I remove the other surface plot.

Thanks Shyam Kishor

Attachments:

1 Reply Last Post 5 lug 2022, 01:25 GMT-4
Shyam Kishor
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 5 lug 2022, 01:25 GMT-4

Hi, I find the answer, just off the plot data set edges option in the setting of stress plot. Thanks.

Hi, I find the answer, just off the plot data set edges option in the setting of stress plot. Thanks.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content