Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error code 999

Posted 24 gen 2012, 04:17 CET Mesh Version 4.2a 1 Reply

Mohamed Elgabaili
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
I am trying to mesh my geometry which is a round parachute canpoy , but everytime an error code number 999 appears and the meshing dosnt go through, the type of mesh I am useing is free tetrahedral. Please I need ur suggestion on this matter.
Best regards
1 Reply Last Post 24 gen 2012, 08:00 CET
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24 gen 2012, 08:00 CET
Hi

meshing is an art, one gain the knowledge how to, by meshing, so be patient.

Try to cut your domain into several smaller ones i.e. 2,3,4 domains and mesh them independently. You add a few "internal" boundaries but often the meshing is simpler

--
Good luck
Ivar
Hi meshing is an art, one gain the knowledge how to, by meshing, so be patient. Try to cut your domain into several smaller ones i.e. 2,3,4 domains and mesh them independently. You add a few "internal" boundaries but often the meshing is simpler -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content