Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Roller problem

Please login with a confirmed email address before reporting spam

Im trying to simulate the deformation under stress of a part I designed. It has an simple roller which i try to simulate by giving it a roller or symmetry condition. But this results in very high stresses which should not be there and also the part that rotates is enlarged by a factor five which is also not supposed to happen. Help is very much appreciated, see the attached file.



0 Replies Last Post 21 dic 2019, 13:20 GMT-5
COMSOL Moderator

Hello Arjen van der Eems

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.