Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

COMSOL with MATLAB

Posted 17 set 2019, 07:23 GMT-4 0 Replies

Ramakant Garhewal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am working with a LiveLink MATLAB. After importing the model from COMSOL to LiveLink MATLAB. This is two transient simulations results from COMSOL to MATLAB.I want to apply a condition to cool the flow channel from the higher temperature. In the inlet gas are Air (Oxygen, Nitrogen and Water Vapor) due to reaction in the channel temperature increasing with the time. After 5 seconds the temperature of the channel is about more than 353K.To restrict the channel temperature, i.e., below 353K.I want to feed only a Nitrogen gas in the gas channel. Please help me in this regards.Where I have to make a change in the code?Please find the attachment of the MATLAB program.

Thank you

0 Replies Last Post 17 set 2019, 07:23 GMT-4
COMSOL Moderator

Hello Ramakant Garhewal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content