Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Moving Edge Load

Please login with a confirmed email address before reporting spam

Was trying to simulate an edge load (line load) which moves down through the surface of a vertical plate. Was checking out multiple examples with moving point source and all, confused in moving a line source . How to proceed. Thanks in advance


2 Replies Last Post 8 lug 2019, 05:50 GMT-4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 8 lug 2019, 02:58 GMT-4
Updated: 5 years ago 8 lug 2019, 02:58 GMT-4

Hi Aswin,

This is an interesting question, and it is not trivial to do this. You need to make use of some of rather advanced modeling techiques, but the possibility to let a line load slide over the mesh using only a few mouse clicks really displays the flexibility of COMSOL Multiphysics.

I have attached a model. The important ingredients are the General Extrusion coupling operator which maps the solution from an arbitrary line to a fixed line, and the Weak Contribution node in which the load is applied at the fixed line, but using the diplacements of the moving line.

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi Aswin, This is an interesting question, and it is not trivial to do this. You need to make use of some of rather advanced modeling techiques, but the possibility to let a line load slide over the mesh using only a few mouse clicks really displays the flexibility of COMSOL Multiphysics. I have attached a model. The important ingredients are the **General Extrusion** coupling operator which maps the solution from an arbitrary line to a fixed line, and the **Weak Contribution** node in which the load is applied at the fixed line, but using the diplacements of the moving line. Regards, Henrik


Please login with a confirmed email address before reporting spam

Posted: 5 years ago 8 lug 2019, 05:50 GMT-4
Updated: 5 years ago 8 lug 2019, 05:49 GMT-4

Dear Henrik,

Thank you for the reply. Let me try .

Dear Henrik, Thank you for the reply. Let me try .

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.