Continue calculation with a single value from a sweep

Please login with a confirmed email address before reporting spam

Hi All,

Here is a situation that occures very often in my optimization problems. I want to do a simulation in two steps:

Step 1: A parametric sweep over the parameter f, where I probe the energy E. Step 2: A single calculation (not a sweep) with f set to the value, where E was largest in the sweep of Step 1.

Is that possible?

Best, Jacob


Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.