Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Can you shift a 2-d cut plane?

Please login with a confirmed email address before reporting spam

Hi,

I've built a 3-d model using MIMICS, but some of my geometry doesn't line up perfectly along COMSOL's coordinate system.

I want to evaluate my 3-d model in 2-d cut plane sections, but I need to rotate my entire model (or just the results) along a single axis. Is there a way to do this in results?

For example, I want to rotate the model 23 degrees in the +Z direction, then I want to look at the corresponding xy plane at certain plane levels.

Thanks,
Ben

1 Reply Last Post 4 nov 2011, 03:10 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 nov 2011, 03:10 GMT-4
Hi

Leave rather your "data set" as is, and add a new extracted data set based on a line or a plane extraction (right click the data set main node)

A good habit: right click most nodes, note that context menu content might change, when you change different physics selections higher up in the structure

--
Good luck
Ivar
Hi Leave rather your "data set" as is, and add a new extracted data set based on a line or a plane extraction (right click the data set main node) A good habit: right click most nodes, note that context menu content might change, when you change different physics selections higher up in the structure -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.