Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coupling RF Module with Semiconductor Module

Please login with a confirmed email address before reporting spam

Hello all,

I am using COMSOL 4.4. I am simulating the effect of an incident electric field wave over a semiconductor substrate. I know the semiconductor and the RF module are not coupled through the multiphysics node, but I wanted to simulate the same model with the RF module and use the results in the semiconductor module. I was wondering if the General Extrusion was a way to go in this application by coupling two components (one using the RF module and one using the semiconductor module). However, I am not sure if this is a suitable application for the General Extrusion.

Jose Santos.


0 Replies Last Post 23 mag 2019, 18:03 GMT-4
COMSOL Moderator

Hello Jose Santos

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.