Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coordinate system and axis orientation in 3D cut plane

Please login with a confirmed email address before reporting spam

Hello Sometimes when you do a 3D cut plane on a geometry, COMSOL shows you the local coordinate system and axis orientation of that cut plane, see attachment 2. And sometimes it does not show, see attachment 1.

My 2 questions are: 1) How can i make COMSOL always show that local coordinate system and axis orientation in a cut plane? 2) How can i change the axis orientation of that local coordinate system?

Thank you


0 Replies Last Post 14 gen 2018, 14:52 GMT-5
COMSOL Moderator

Hello Manuel Ayala

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.