Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Designing a cantilever with narrow strip at the hinged part
Posted 5 feb 2011, 02:34 GMT-5 2 Replies
Please login with a confirmed email address before reporting spam
sir,
may i know how to design a cantilever in 3.5a and 4.1 comsol versions for the given structure.
may i know how to design a cantilever in 3.5a and 4.1 comsol versions for the given structure.
Attachments:
2 Replies Last Post 6 feb 2011, 00:15 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
all depends how and what you want to study.
you can start in 2D draw 2 or 3 rectangles side by side, define the "thickness" depth in "Z" direction (out of paper) , define the material properties and then go on.
You can also consider the large block as rigid and just not inlude it at all (depends on the details you are looking for)
Then in 3D you draw 3 blocks, side by side
To learn how to use the CAD section perform some of the exercices that are described in detail in the doc
There is basically no differences (apart from the GUIs) between 3.5 and 4 for the geoemtry build up
--
Good luck
Ivar
all depends how and what you want to study.
you can start in 2D draw 2 or 3 rectangles side by side, define the "thickness" depth in "Z" direction (out of paper) , define the material properties and then go on.
You can also consider the large block as rigid and just not inlude it at all (depends on the details you are looking for)
Then in 3D you draw 3 blocks, side by side
To learn how to use the CAD section perform some of the exercices that are described in detail in the doc
There is basically no differences (apart from the GUIs) between 3.5 and 4 for the geoemtry build up
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you for your help