Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

CFD Simulation

Please login with a confirmed email address before reporting spam

Hello

I'm trying to calculate the drag coefficient on differents geometries but I have a problem because I chose two materials, one for the CAD that I imported and other (air) for the box that I drew but I don't know if this is an assembly or a part.

Then when the postprocessing begins, it has a loop and never finish.

Thanks for your attention.

Best wishes.

Esteban Valderrama Agudelo

1 Reply Last Post 13 gen 2011, 13:14 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13 gen 2011, 13:14 GMT-5
a
a

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.