Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Turbine flow
Posted 16 dic 2010, 08:32 GMT-5 Fluid & Heat Version 4.0 1 Reply
Please login with a confirmed email address before reporting spam
Hello
This files attachments contains the 3D and 2D modeling of a CFturbine
As I try to solve the problem the following massage pops up: evaluation of plot mesh vertex coordinates fail.
Properties of mode: The turbine must have a constant angular vol' as well as the inlet to the wind tunnel
I changed the speed to a smaller value and meshed it in finer elements. And it wouldn't compile.
Hope you can help me understand the problem.
Sincerely
Gilad Mymon
This files attachments contains the 3D and 2D modeling of a CFturbine
As I try to solve the problem the following massage pops up: evaluation of plot mesh vertex coordinates fail.
Properties of mode: The turbine must have a constant angular vol' as well as the inlet to the wind tunnel
I changed the speed to a smaller value and meshed it in finer elements. And it wouldn't compile.
Hope you can help me understand the problem.
Sincerely
Gilad Mymon
1 Reply Last Post 16 dic 2010, 08:39 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
For some reason the file is not uploaded prop