Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
How to put the result of the first model as an initial condition (or initial value) into the second model
read3 Replies 1186 ViewsVersion 5.6 Studies & Solvers
Tao Zhou posted 2 years ago reply 2 years ago by Mark Harradine
-
0 Replies 73 Views
Version 6.1 Computational Fluid Dynamics (CFD)Studies & SolversPhysics Interfaces
Anurag Rajan posted 2 years ago
-
0 Replies 174 Views
Version 5.4 Wave OpticsMeshStudies & Solvers
Ali Vafa posted 2 years ago
-
Error Using MATLAB to Simulate a Line Scan of a Multiturn Differential Coil Above a Conducting Plate
read1 Replies 83 ViewsVersion 6.1 LiveLink for MATLABStudies & Solvers
Joey Marano posted 2 years ago reply 2 years ago by Lars Gregersen
-
0 Replies 45 Views
Version 5.6 Studies & Solvers
-
0 Replies 38 Views
Version 6.1 APIOptimizationStudies & Solvers
Hendrik posted 2 years ago
-
0 Replies 62 Views
Version 5.6 Studies & Solvers
-
0 Replies 109 Views
Version 5.3a Structural & AcousticsAcoustics & VibrationsStudies & Solvers
宇宣 林 posted 2 years ago
-
0 Replies 86 Views
LiveLink for MATLABMeshStudies & Solvers
xi ye posted 2 years ago
-
1 Replies 91 Views
Studies & SolversStructural Mechanics
Kayla Lowry posted 2 years ago reply 2 years ago by Acculution ApS
