SIMULATION SUCCESS STORIES

Simulating a Half-Cell Battery with COMSOL Multiphysics®

Energy

Mikael Cugnet
French Atomic and Alternative Energy Commission

Battery management systems (BMSs) are designed to protect the batteries and predict their charge level. They use circuit models often derived from electrochemical impedance spectroscopy (EIS) measurements to construct an equivalent circuit model (ECM) that consists of resistors and capacitors connected both in series and in parallel. Yet, ECMs do not provide any information about important cell properties like the electrode active material resistance, the reaction rate, the specific capacitance, or the diffusion coefficient.

A multiphysics model of a LiFePO4/Li half-cell can provide more information than a typical circuit model. The French Atomic and Alternative Energy Commission (CAE), France’s largest technology research organization, worked to develop a method for simulating Li-ion batteries in COMSOL Multiphysics. The first of these models includes all components of the half-cell battery, while the second specifically models the iron phosphate electrode. This allowed CAE to analyze the behavior of the material before re-designing and making the actual battery.

LiveLink™ for MATLAB® was used to process the results and receive the full impedance spectrum of the half-cell. Implementing an electric double layer in COMSOL Multiphysics helped them simulate the nonlinear behavior that is typically observed for a battery at higher operating frequencies. By using COMSOL Multiphysics to simulate a half-cell battery, they can optimize their design with an electrode material that is more conductive, and they confirmed that a model incorporating an electric double layer better reflects device behavior.

  •  /
1
Loading PDF...

Suggested Stories

Meeting High-Speed Communications Energy Demands Through Simulation

Meeting High-Speed Communications Energy Demands Through Simulation

The information and communication technology industry needs new energy-efficient devices that can keep up with the ...

Optimizing a CVD Process for a High-Performance Tungsten Material

Optimizing a CVD Process for a High-Performance Tungsten Material

Researchers at Forschungszentrum Jülich GmbH, Institute for Energy and Climate Research, and Max Planck Institute for ...

Better Ways to Heat and Cool Buildings

Better Ways to Heat and Cool Buildings

Adsorptive climate control systems can reduce the power required to heat and cool buildings by running primarily on ...

Lighting the Way for Improved Synchrotron Vacuum Chambers at RadiaSoft

Lighting the Way for Improved Synchrotron Vacuum Chambers at RadiaSoft

One of the goals of the Argonne National Laboratory (ANL) is to increase the brightness of synchrotron beams for the ...