Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo

In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.


Visualizza gli articoli presentati alla COMSOL Conference 2020

Transport Phenomenax

COMSOL Multiphysics® Models as the Design Guidance in the Selected Transport Phenomena Problems

S. Spotar [1],
[1] Nazarbayev University, Astana, Kazakhstan

This paper demonstrates experience of using the COMSOL Multiphysics® transport phenomena models in design practice, particularly at the early stage of design when there is might be too many possible design suggestions relying on the shell balance equations, and engineering intuition. ... Per saperne di più

Spatial Dynamics of Insecticide Resistance in Mosquitoes

O. Richter [1],
[1] University of Technology Braunschweig, Germany

Mosquito- borne diseases are resurgent due to insecticide resistance. In this paper a model is presented combining insect dispersal and population genetics for the simulation of the emergence of pesticide resistance in dependence on management practices. Dispersal of populations and ... Per saperne di più

Partial Discharge Risk Under Charge Generation and Transport Effects

M. E. Banda [1], D. Malec [1], J-P. Cambronne [1],
[1] LAPLACE, Université de Toulouse, CNRS, INPT, UPS, France

The good electrical, thermal, mechanical and chemical properties of solid organic dielectrics, such as PTFE, predestine them as good candidates for the electrical insulation of transport devices and systems. In the particular case of power converters involved in the future hybrid and ... Per saperne di più

Computational Fluid Dynamics Approach to Evaluate Electrostatic Precipitator Performance

M. Ahmadi [1]
[1] Faculty of Engineering Technology, University of Twente, Enschede, The Netherlands

Electrostatic precipitation is an extremely efficient way of filtering fine particles from the airstream. Electrostatic precipitators (ESPs) can control airborne emission without significantly slowing down the rate of flow, because of the low pressure drop across this type of filters. A ... Per saperne di più

Effects of Geometry and Operating Conditions on Membrane Reactor for Water Gas Shift Reaction

D. Shin [1], T. Kim [1], J. Lee [1]
[1] Altsoft Inc., Seoul, South Korea

Recently, hydrogen is widely used as environmental energy and high energy content. The hydrogen is mainly produced by water gas shift reaction(WGSR) from coal to hydrogen process in Integrated Gasification Combined Cycle(IGCC) plant. WGSR, well known for hydrogen production, is a ... Per saperne di più

Inverse Analysis of Soil Parameters Based on Deformation of a Bank Protection Structure

Y. Xing [1], R. Hu [2], Q. Liu [1],
[1] Geoscience Centre, University of Goettingen, Goettingen, Germany
[2] School of Earth Science and Engineering, Hohai University, Nanjing, China

Deformation prediction is an important part of the structure stability analysis. However, the deformation of bank protection structure which is affected by many factors, such as structural stiffness, earth pressure and hydrostatic pressure. It contains a complex mechanical process, which ... Per saperne di più

Simulation of Heat and Mass Transfer During Artificial Ground Freezing in Saturated Saline Groundwater

Q. Liu [1], R. Hu [2],
[1] Geoscience Centre, University of Goettingen, Goettingen, Germany
[2] School of Earth Science and Engineering, Hohai University, Nanjing, China

With the extensive application of ground freezing method in coastal areas, the groundwater environment during ground freezing has been changed. Especially in seawater intrusion areas, groundwater salinity is high (even salinity equivalent to sea water (ca. 35g/L)). Engineering experience ... Per saperne di più

3D Simulation of an Ethanol Reformer

A. Cifuentes [1], J. Llorca [1], R. Torres [1], S. Rosell [1], J. Grau [1]
[1] Universitat Politècnica de Catalunya, Barcelona, Catalonia, Spain

In order to improve hydrogen production in an ethanol reformer it is needed to understand what happens inside it. Also, a simulated model can simulate different work conditions avoiding the necessity of doing tons of experiments. A 3D computational fluid dynamics simulation study of ... Per saperne di più

Analysis of Mixing Chambers for the Processing of Two-Component Adhesives for Transport Applications

P. Steinert [1], R. Paul [1], I. Schaarschmidt [1], M. Zinecker [1], M. Hackert-Oschätzchen [1], Th. Muschalek [2], J. Esslinger [2], A. Schubert [1]
[1] Professorship Micromanufacturing Technology, Chemnitz University of Technology, Chemnitz, Germany
[2] Rublic+Canzler GmbH, Dresden, Germany

Two-component adhesives are commonly used for sealing and joining in transport applications for mechanically highly stressed connections. At the Chemnitz University of Technology an innovative system technology for the user-friendly, wireless and energy-efficient processing of two ... Per saperne di più

Simulation of Auxin Accumulation and Transport in a Plant Root

M. A. Akhmanova [1], M. Fendrych [1], J. Friml [1]
[1] Institute of Science and Technology Austria, Klosterneuburg, Austria

Plant roots have an outstanding ability to grow in the direction of gravity or nutrients. Bending of the root tip in the preferred direction is achieved by asymmetric cell growth on the opposite sides of the root, dictated by asymmetrical distribution of the hormone auxin. Increase in ... Per saperne di più