Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
Heat sinks for cryogenic applications using helium gas as the coolant are not readily available. They require to be designed specifically for the intended application. A finite element model was developed to study the feasibility and optimize the design. The FEM computing package COMSOL ... Per saperne di più
Metacomposites are new class of materials with unusual properties that can be engineered using existing materials with usual properties. The unusual properties of metacomposites are derived from the structure, analogues to atomic arrangement in crystal lattice. These material exhibits ... Per saperne di più
A finite element model of a polymer electrolyte membrane fuel cell (PEMFC) is described in this paper. We divide the PEMFC into two separate and parallel 2D regions which are connected by the 1D regions representing the membrane electrode assembly (MEA). COMSOL Multiphysics® was used as ... Per saperne di più
The flow of self-consolidating concrete (SCC) in formwork fillings was simulated as the flow of a single phase yield-stress fluid between two infinite plates by COMSOL Multiphysics®. The flow of SCC with varied rheological properties (yield stress and plastic viscosity) was verified in ... Per saperne di più
The design of a magnetic resonance imaging (MRI) RF coil using finite element method-based analysis is an essential part of a multi-year research project at the National Institute of Standards and Technology, Gaithersburg, Maryland, where the goal of the project is to develop a “phantom” ... Per saperne di più
A 2D isothermal axisymmetric model of an anode-supported Solid Oxide Fuel Cell (SOFC) has been developed. Also a parametric analysis to find the effect of important parameters on the cell performance has been done. This simulation has been carried out at 1 atm and 1073 K. The PEN ... Per saperne di più
Patients undergoing surgery are sensitive to infections. The operation staff may spread 10^4 particles per person per minute, of which ten percent are presumed bacteria-carrying. We visualize the influence of the personnel on the air and particle flows for the two most common ventilation ... Per saperne di più
Since October 2009 the laboratory of ATE has carried out collaborative research with the WTD 71 that aims for prediction, reduction and optimization of so-called underwater electric potential (UEP) signatures. COMSOL is used to simulate potential distributions in the context of impressed ... Per saperne di più
The article deals with the magnetically-supported high-power full-penetration laser beam welding of aluminum. A stationary simulation was conducted accounting for the effects of natural convection, Marangoni convection and solid-liquid phase transition as well as an electromagnetic ... Per saperne di più
In this paper, the effects of roughness in the surfaces of the plates caused due to nonuniform etching during their release and/or due to defects in the original wafer on the capacitance in RF-MEMS parallel plate varactors are analyzed. Capacitance extraction due to surface roughness has ... Per saperne di più