Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
Introduction: RFID system uses a Transponder and the near field communication (NFC) antenna and a matching circuit (Figure-1) in which at least latter two must be optimally designed for a higher efficiency. Typically, RFID antennas are flat inductive coils with 2 to 4 turns and are ... Per saperne di più
This paper summarizes the main features of the on-interposer micro-thermoelectric sensors (hereafter denoted by µTES) derived by means of simulations done with COMSOL Multiphysics® software. µTES are thermal sensors based on the Seebeck effect which converts thermal flow into electrical ... Per saperne di più
Bolometers are used in a number of applications including night vision cameras, astronomy, and particle physics to measure the power of incident electromagnetic radiation. The general principle of operation is shown below: a strip of conducting material is exposed to incident ... Per saperne di più
We demonstrate cartogram construction, where a geographical map is distorted to represent some measure, for example population, while trying to keep the shape of regions recognizable. We then apply this cartogram construction technique to optimize thermocouple locations. A heat ... Per saperne di più
HazRes has developed a gas discharge and dispersion model in COMSOL which takes into account the effects of localized wind profiles and turbulence generated by buildings, structures and terrain on the dispersion of gases in question. The main focus of this work is to develop and provide ... Per saperne di più
In this project, we are aiming towards the development of an impedimetric biosensor based on nanoporous silicon structures for the detection of small molecular size and low weight food toxins (like Aflatoxin). Existing sensors for such toxin detection fail to achieve high sensitivity ... Per saperne di più
One of the most promising categories of semiconductor-based sensors is organic electrochemical transistor (OECT), which consists of three electrodes (Source, Drain and Gate) and two active layers: electrolyte and conductive polymer. Despite the fact that OECT attracts a lot of attention ... Per saperne di più
Due to the increasing demand for hydrogen gas sensors for applications such as automation, transportation, or environmental monitoring, the need for sensitive and reliable sensors with a short response time is increasing. This paper presents an empirical model that studies the ... Per saperne di più
Tuberculosis is infectious disease caused by various strains of Mycobacterium tuberculosis. The detection is very difficult because their mechanism is not well understood, and it is mainly based on the γ interferon which is normally secreted by the T-cell of the body. The RD1 region is ... Per saperne di più
Nanoscale structural analysis and design is presented. All the simulations are carried out using a finite element solver and optimization is performed using parameter and topology optimization schemes. It is concluded that COMSOL is effective for analysis and design of nanoscale ... Per saperne di più