Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
In-service detection of fatigue cracking in metallic aerospace structures relies on capable and efficient eddy current inspection procedures. For best results, inspections with surface scanning eddy current techniques are following rigorous procedures that indicate the instrument ... Per saperne di più
• Real-time detection and monitoring of bio-fuel blend-ratio and adulterated automobile fuels by a reproducible micro-fabrication process in a cost-and-time efficient manner. • COMSOL Multiphysics® simulations and modelling of Viscosity based Laminar Flow inside a Y-shaped Micro ... Per saperne di più
Over the past two decades, extensive research has been conducted on ultraviolet (UV) photodetectors (PDs) because of their potential applications across various fields including military, medicine, environmental monitoring, and deep space explorations. To fabricate solar-blind UV PDs ... Per saperne di più
We are developing a solid state gas sensor that combines a small form factor with the high sensitivity of optical gas detection. The gas sensor is based on an optical resonant microsystem that is penetrated by gas molecules. This microsystem consists of an array of vertical rods in air ... Per saperne di più
With the progress of immunosensing technology, the detection of diseases at early stages is feasible using surface based heterogeneous immunosensors [1]. Literature contains few reports where it is verified that reaction spot of smaller size leads to high fractional occupancy of targets, ... Per saperne di più
Conventional eddy current techniques have been used to a great extent for detection of surface breaking defects in conductive materials. However, detection of sub-surface defects is limited due to the single frequency and skin effect phenomena. Pulsed Eddy Current (PEC) techniques ... Per saperne di più
Silicon based MEMS have wide applications in under water sensors. This work aims one such applications, hydrophone. Hydrophone detects the pressure variations of acoustic signals and noise in the water and produces an output voltage proportional to the pressure. Here the attempt is made ... Per saperne di più
We demonstrate a broadband metamaterial (MM) absorber for THz frequencies. The MM was characterized in the spectral region of 0.3 - 3 THz with THz Time domain spectroscopy (TDS) using 1 mm ZnTe crystal for Electro-optic detection. A strong broadband resonance is observed, centered around ... Per saperne di più
Residual Gas Analyzers (RGA) are often used to measure background gases and contaminations in vacuum systems. An ionizer is used to ionize gas molecules and these ions are accelerated and focused by an electrical field from the ion source to form an ion beam. The ions can be ... Per saperne di più
Detecting light emitted by fluorescent molecules with resolution down to single photon is an important problem in various fields of sciences and applications, such as solid-state physics, quantum information processing and medicine. The detection probability can be improved via ... Per saperne di più