Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
La modellazione e simulazione multifisica favorisce l’innovazione in numerosi settori industriali e nel mondo accademico, come dimostrano le molteplici applicazioni illustrate negli articoli tecnici e nei poster presentati ogni anno da ingegneri, ricercatori e scienziati alla COMSOL Conference.
Lasciati ispirare dai recenti contributi raccolti qui sotto oppure, per trovare una presentazione specifica o filtrare i risultati per area di applicazione, anno o sede della conferenza, utilizza lo strumento di Ricerca Rapida.
Visualizza gli articoli presentati alla COMSOL Conference 2025
Natural convection has to be accounted and simulated for in order to properly describe the physics encounter in the phase change process. A simplified two-dimensional model was created in COMSOL 4.1. Natural convection was accounted for by adding a volume force and using the Boussinesq ... Per saperne di più
This paper investigates the evolution of a single bubble going through growth, pinch-off, and condensation while rising due to buoyancy forces in a sub-cooled liquid. Phase change is modeled on the evolving liquid-vapor interface by considering changes in enthalpy and heat fluxes at the ... Per saperne di più
The High Flux Isotope Reactor (HFIR) at the Oak Ridge National Laboratory (ORNL) is an 85 MW, light-water moderated, research reactor that operates at low temperature and high pressure. The HFIR is presently scheduled to convert from a high enriched uranium fuel (HEU) to a low enriched ... Per saperne di più
Micro-scale devices based on the Stirling cycle are an attractive choice for chip- and board-level electronics. A new Stirling cycle micro-refrigeration system composed of arrays of silicon MEMS cooling elements has been designed. COMSOL is used to evaluate the thermal performance of ... Per saperne di più
Using COMSOL® 3.5a, models were created to simulate the heat transfer between the working fluid and the selective coating as well as the natural convection of the working fluid itself. In these models, a constant heat input on half of the selective coating facing the sun was considered ... Per saperne di più
COMSOL Multiphysics can be used to model a latent heat energy storage system. A 2D numerical study was performed to simulate melting of a PCM including both conduction and convective heat transfer. The heat transfer in fluids and laminar flow physics interfaces were used. To model ... Per saperne di più
Jos van Schijndel completed his MSc in 1998 at the Department of Applied Physics at the Eindhoven University of Technology (TUe). In 2007 he obtained a PhD degree at the TUe on integrated heat, air and moisture modeling. Currently, he is assistant professor focusing on Computational ... Per saperne di più
In this study, computational fluid dynamics analysis software (COMSOL Multiphysics) is used to predict heat transfer for the hot-pressed mold of semiconducting vacuum laminator. The predicted results are compared with the experimental measurements to verify the accuracy of simulations. ... Per saperne di più
