Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Line to table

Posted 21 set 2010, 05:06 GMT-4 1 Reply

Matthias K
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I would like to collect all electric field strength values along a defined path into a table to work with these values in excel. Is there any comfatable way? I am new to comsol so please excuse this maybe very simple question.

Thank you
Matthias
1 Reply Last Post 21 set 2010, 06:05 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 decades ago 21 set 2010, 06:05 GMT-4
Hi

in V4 yes its standard line plot copy to excel,
in v3.5 probably you need to use either a plot dump in ascii, or matlab

--
Good luck
Ivar
Hi in V4 yes its standard line plot copy to excel, in v3.5 probably you need to use either a plot dump in ascii, or matlab -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content