Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Jump in velocity profile before the exit from the plate reactor

Please login with a confirmed email address before reporting spam

I am trying to do plate model for the methane steam reforming, and for this I have used weakly compressible Navier-Stokes, convection-diffusion and convection-conduction modules in comsol, everything is running ok except I am getting an unexpected result in velocity near to exit of the plate reactor, plz see the attached jpg file of the velocity profile..anyone know why this happening..thanks


2 Replies Last Post 20 mag 2010, 19:09 GMT-4

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 mag 2010, 17:46 GMT-4
did you try refining the mesh toward the exit?
did you try refining the mesh toward the exit?

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 mag 2010, 19:09 GMT-4
Yes I have tried everything..I have also tried it with low tolerance.
Yes I have tried everything..I have also tried it with low tolerance.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.