Frequency study not converging

Please login with a confirmed email address before reporting spam

These two files have been uploaded, one is the planar layer only and other is planar with a dielectric layer.

The coil geometry analysis + stationary study works fine in both the cases, but while doing freq study with freq sweep as 0.1,0.5,1,10,25,50,75,100 KHz , the one with dielectric is not converging as the error is not going 0.

Is there any prob with the geometry pr some issue with the study.



1 Reply Last Post 15 gen 2026, 10:54 GMT-5
Edgar J. Kaiser Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 3 hours ago 15 gen 2026, 10:54 GMT-5

Anushka,

the mesh in the dielectric isn't looking good. You may want to refine that. There is no study definition in your file.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Anushka, the mesh in the dielectric isn't looking good. You may want to refine that. There is no study definition in your file. Cheers Edgar

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.