Using current dependance in Joule heating module

Please login with a confirmed email address before reporting spam

Hello everyone, I've just started learning how to use COMSOL.

I'm using the Joule Heating module to model a conductor connected to an electric potential on one side and grounded on the other to analyze heat transfer. Everything works perfectly when I use only the electric potential. However, when I try to analyze the heat dependence of the conductor using a constant current (by applying a Terminal condition), nothing changes after computing in terms of temperature.

How can I change the model depends only on the current instead of the voltage? How should I modify the model to reflect this?

Any ideas, suggestions, or advice would be greatly appreciated!**


Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.