Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Properties of model

Please login with a confirmed email address before reporting spam

Hey.

How can I check the properties of the model object?
For example, the current in the coil, or the radius of the circle, the properties of the materials.

Thank you.

3 Replies Last Post 26 feb 2013, 08:43 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 feb 2013, 14:08 GMT-5
Hi

you can only post-process after having solved, or loaded the initial conditions, then you can use the Derived values node to integrate and interprete results around your domains or boundaries

--
Good luck
Ivar
Hi you can only post-process after having solved, or loaded the initial conditions, then you can use the Derived values node to integrate and interprete results around your domains or boundaries -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 feb 2013, 07:08 GMT-5
Thank you for your reply.

But I had in mind early formula
geom1.feature.create c1 = ('c1', 'Circle');
You can find out where the property value before calculating.

Thank you.
Thank you for your reply. But I had in mind early formula geom1.feature.create c1 = ('c1', 'Circle'); You can find out where the property value before calculating. Thank you.

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 feb 2013, 08:43 GMT-5
Hi

you can do measurements in the graphics view see the ruler icon, but any "calculation" is performed on the discretized geometry, hence you need a mesh and at least loading in the initial conditions into the Data sets

--
Good luck
Ivar
Hi you can do measurements in the graphics view see the ruler icon, but any "calculation" is performed on the discretized geometry, hence you need a mesh and at least loading in the initial conditions into the Data sets -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.