Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Simulation of corrosion via COMSOL
Posted 24 dic 2024, 22:28 CET Corrosion & Corrosion Protection, Results & Visualization, Modeling Workflow Version 6.2 0 Replies
Please login with a confirmed email address before reporting spam
Dear Sir, I am simulating a Galvanic corrosion event via COMSOL. But, I want to get ultimately the potentiodynamic polarization plot or roughly speaking the "Tafel" plot. So, for that I have done a parametric sweeping study with the varying applied potential with a range and step size. I want to ask about the data extraction and plotting the potentiodynamic polarization plot by the extracted data. The result section is huge and confusing. Please give a few instructions. Also, where in the model, I should add that parametric sweeping E_applied as a boundary condition?
Regards.
Hello Ravishankar Suman
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.