Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

FRF of duffing oscillator attached to beam

Posted 1 mag 2023, 04:17 GMT-4 Modeling Tools & Definitions, Structural Mechanics, Structural Dynamics Version 6.0 3 Replies

Arghya Mondal AEROSPACE
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I need an FRF study of duffing oscillator attached to a beam. Can anyone please help me out to model this system?

3 Replies Last Post 8 mag 2023, 02:57 GMT-4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2 mag 2023, 05:25 GMT-4

Since it is a nonlinear problem, it is diffcult. Ordinary frequency domain analysis is not applicable.

There are two possible approaches:

  • Run a time dependent solution to steady state for each excitation frequency. This is time consuming.
  • Implement a harmonic balance method. This assume quite some familiarity with the software.
-------------------
Henrik Sönnerlind
COMSOL
Since it is a nonlinear problem, it is diffcult. Ordinary frequency domain analysis is not applicable. There are two possible approaches: * Run a time dependent solution to steady state for each excitation frequency. This is time consuming. * Implement a harmonic balance method. This assume quite some familiarity with the software.
Arghya Mondal AEROSPACE
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 5 mag 2023, 14:51 GMT-4

Can you please explain little bit about the implementation of harmonic balance method in comsol for the above problem?

Can you please explain little bit about the implementation of harmonic balance method in comsol for the above problem?
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 8 mag 2023, 02:57 GMT-4

I don't have an example of an implementation of the harmonic balance method, but I know it has been done in COMSOL for electrical simulations.

A short introduction to the method can be found in https://en.wikipedia.org/wiki/Harmonic_balance

I think the easiest (but maybe not very elegant) approach is to add one physics interface per harmonic, each operating at its own frequency. Then, coupling terms need to be inserted for the transfer of energy between the frequencies which is an effect of the nonlinearity.

-------------------
Henrik Sönnerlind
COMSOL
I don't have an example of an implementation of the harmonic balance method, but I know it has been done in COMSOL for electrical simulations. A short introduction to the method can be found in I think the easiest (but maybe not very elegant) approach is to add one physics interface per harmonic, each operating at its own frequency. Then, coupling terms need to be inserted for the transfer of energy between the frequencies which is an effect of the nonlinearity.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content