Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Slip Wall Function on Parallel Plates Gives Different Results

Please login with a confirmed email address before reporting spam

Hi folks,

I am trying to implement a No-Slip Wall Function in a K-Epsilon Turbulence Model on parallel plates.

I don't want to use a Low Re K-Epsilon Model from COMSOL.

So I impose a Slip Wall Function on both plates and use a pointwise constraint to make the velocity zero
at the plates.

However I get different results on each plate!!

I have tried to implement a friction velocity and impose the zero velocity for each plate separately amongst other
attempts but to no avail...

Can anyone provide some insight or info into this matter?

Best Regards,

Rui Silva


0 Replies Last Post 19 apr 2012, 11:05 GMT-4
COMSOL Moderator

Hello Rui Silva

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.