Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress in Thin Film for Self-Curving

Please login with a confirmed email address before reporting spam

Hello, I just want to say I am new at COMSOL so this might be trivial, but thank you for any help you can provide!

I am trying to simulate using swelling (or stress or strain, whatever works) to create curving in a thin-film of a polymer (SU8). I created a simple thin rectangle and made the hydroscopic swelling coefficient proportional to z. I put one point in the middle of the bottom face and made that the point constraint for the structure.

In theory, the film should fold into a cylinder like in this research paper in Figure 3a, because of the stress gradient in the z direction: https://www.nature.com/articles/ncomms1531 . However, it only gets to the point in the image attached here (with the deformation scaled by 10), before getting a non-convergience error. It does not complete the curve into a cylinder. Would it be possible to model the whole curving using COMSOL, and if so, do you have any advice for how I can model this correctly? My COMSOL file is also attached here.

Thank you so much!



0 Replies Last Post 27 ott 2020, 23:06 GMT-4
COMSOL Moderator

Hello Carol Mikhael

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.