Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

problem on getting frequency responce

Please login with a confirmed email address before reporting spam

Hello everyone,

I am modeling a structural mechanics with ale mesh frame and electrostatic in this frame.. in an axi-symmetric 2d model (MEMS module)..

The problem is ... When I solve for the eigenvalues I got a resonance at 1MHz and then at 4.1MHz and the third at 9MHz

but when I solve for the frequency response analysis I found different result


thanks you so much for your support


yours
Mark George

3 Replies Last Post 11 feb 2012, 04:05 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 feb 2012, 03:54 GMT-5
kindly find the design attached
kindly find the design attached

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 feb 2012, 03:54 GMT-5
kindly find the design attached
kindly find the design attached

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 feb 2012, 04:05 GMT-5
kindly find design attached
kindly find design attached

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.