Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Information about edges

Please login with a confirmed email address before reporting spam

HI! I need to make an explicit selection of some edges of my geometry. It's difficult to do it manually, so I'd like to implement it in Matlab. Is there any place where the information about edges is saved? When you select and edge, I see that it has an ID, so I'd like to know the ID and the initial and ending point of every edge. Is that possible?

Thanks and regards. Alfonso


0 Replies Last Post 14 ott 2019, 08:17 GMT-4
COMSOL Moderator

Hello Alfonso de la Vega

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.