Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Giving inputs to Bezier Polygon

Please login with a confirmed email address before reporting spam

I am using Comsol 5.2a.I have created a pipe like structure by drawing quadratic lines and circles.Then i did the sweep fuction.After doing this, i have got the structure which is showed in the attached file.Now my question is that,how can i give inputs like height,width to this structure?


0 Replies Last Post 27 lug 2017, 02:53 GMT-4
COMSOL Moderator

Hello Abu Syed Sajib

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.