Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electrospinning_doc file attached

Please login with a confirmed email address before reporting spam

Dear Administrator/anyone in discussion form,

I have attached the doc file for electrospinning simulation.

I am unable to get correct result.

Would you help me with this?

I am using a single needle and a rotating drum.

I am not sure what mistake I have made here.

Please verify.

Thanks,
Blesson


0 Replies Last Post 9 mag 2017, 21:35 GMT-4
COMSOL Moderator

Hello Blesson Isaac

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.